Dollar Tree Diy's · Thrift Flips

High End Decor Dupe DIY’s On A Dollar Budget

High End Decor Dupes On A Dollar Budget

This page contains affiliate links. If you purchase through these links I will receive a small commission at no additional cost to you.

If your like me, I love to browse through high end stores, but every time I pick up an item to look at the price tag….I gasp and quickly tell myself, I can make that for a lot less. With the cost of everything sky rocketing these days, I can’t afford to spend $60 on wall art, or $100 on a lamp. Today I will show you how I created 5 decor dupes on a dollar store budget. Once your finished reading, make sure to leave me a comment at the bottom of the page letting me know which one was your favorite❤️

Photo Frame Ladder Decor Dupe

On a recent trip to Dollar Tree, I came across 4X4 beaded wood photo frames. Even though I quickly purchased 5 of them, I will only be using 4 for this project. I saved the fifth one to do a separate project with.

You will also need 4 wooden garden stakes from Dollar General. They sell these for $1 a piece. I thought I could make this using three garden stakes, but you will need the fourth one to complete the project.

Cut two of the garden stakes down to 34 3/4″ each, then cut five 8″ pieces using the other two garden stakes.

Make sure to give each one a good sanding because this wood is pretty rough.

Measuring from the left hand side, make a mark on each of the 8″ pieces at 1 5/8″ and 6 3/8″, try to mark them in the center of the wood pieces, like this.

Using a 5/16ths drill bit, drill a hole through each of your marks. Make sure to place these on another block of wood to protect your work surface.

You will likely have to re sand these to clean the holes up.

Lay your two 34 3/4″ garden stakes side by side and make a mark at the following measurements: 1″, 9″, 17″, 25″, and 33″

Using these marks, you can line up your 8″ pieces and glue the ends to your larger garden stakes using wood glue. Make sure your holes are on the sides as you glue them down, as seen here:

To make sure your glue seals well to each piece, clamp the pieces together and let the glue set up for several hours.

The Frame Is Complete!

You can paint or stain your project your desired color. I preferred the natural wood look, and the beaded wood frames match perfectly with the garden stakes, so I didn’t paint or stain mine. Using Dollar Tree nautical rope, feed one end through each hole on one side and tie a knot.

Pull the rope from left to right to tighten as you go and tie another knot at the opposite end.

Once that side is complete, add the nautical rope to the other side the exact same way. To attach the frames to the nautical rope, apply hot glue lining the beaded portion up with the nautical rope.

Try to keep the frames centered in each section as you add all four frames.

If you prefer, you can also add staples to the back to secure the frames to the rope.

You are still able to access the backing of each frame and change your photos out.

The Final Result

We were able to create this for $10.25 verses the high end stores price of $79.99!

Pampas Grass Beaded Frame Decor Dupe

Granted our dupe will not be the exact same size as the inspiration piece because we are using an 11X14 frame from Dollar Tree.

To give this the antique gold look, you could spray paint the frame or use Folk Art’s Metallic Antique Gold acrylic paint like I did. This really helped to bring out the details on the edge of the frame.

For the fabric backing, we will be using a flour sack. You can purchase a pack of two at Dollar General.

Add a layer of Mod Podge to the glass and allow it to fully dry.

My Favorite Way To Use Mod Podge, Leaving No Wrinkles!

Set the glass onto a heat protective mat, lay your flour sack on top of the side of the glass with the dry Mod Podge. Set a piece of parchment paper over the flour sack. Using a small iron, gently and carefully go over the parchment paper to adhere the flour sack to the glass. I have my iron set on around 300 degrees Fahrenheit. The heat from the iron will “reactivate” the Mod Podge allowing the fabric to seal to the glass.

Give the glass time to cool down, flip it over and set it on a cutting board. Using a utility knife, carefully remove the excess fabric from the edges.

You could reinsert this into the frame and continue, however I didn’t like the stark white look of the fabric.

To really make the fabric stand out, I painted it with a coat of chalk paint in the color French Linen. Because the chalk paint is fairly thick, you may want to water it down a bit to avoid streaking and clumps.

Allow time for the paint to fully dry before reinserting into the frame. The paint gave the fabric a velvety look.

Using some pampas grass that I already had in my craft room. I gave it a good shake to remove any loose particles. To help it hold its shape, I lightly misted both sides with hair spray. You can find similar pampas grass at Amazon.

Once you have your desired shape, simply glue the grass bundle to the fabric using hot glue or the glue of your choice.

Because I already had the pampas grass and paint on hand, this project cost me less than $3.00 to make.

Metal Milk Can Decor Dupe

Luckily, I have a metal cookie container that resembles the shape. This is a true trash to treasure project.

After removing the label and giving this a thorough cleaning, I took it outside and gave it two light coats of a high gloss white spray paint.

To achieve the distressed galvanized look, I used a piece of a bath sponge from Dollar Tree, a dry brush, and Folk Art’s Metallic Acrylic paint in the color gun metal gray.

I started at the top rim using the dry brush, applying paint to all of the rims including the handles.

To achieve the larger galvanized areas, I used the sponge piece and lightly dabbed the paint in all the areas that I thought looked good.

This project did not cost me anything, because I already had all the supplies! By giving this container new life, we saved it from the landfill.

High End Lamp Decor Dupe

About 4 years ago, I turned a glass bottle into a lamp. If your interesting in watching that video, here is the link.

As much as we have enjoyed the faux marble look, it was definitely time for a change. To prep for paint, I wrapped all the parts that I did not want paint to get on with painters tape.

I found this beautiful textured spray paint at Lowes. It was perfect because it had tiny white speckles in it.

Because textured spray paint costs more than regular matte spray paint. I applied two thin coats of the cheaper paint to the lamp first and allowed that to dry over night.

The next day, I applied two coats of the textured spray paint, going in several different directions.

I love the final result! It gave my DIY lamp a higher end and more modern look. And it only cost me one bottle of textured spray paint.

If you prefer to watch the step by step tutorial, click my YouTube video below.